I don’t own a full-size buffer because my lapidary equipment fills the worktop in my shop. Most of the time I can get by using my flex shaft to polish the metal sections of my work, but there are times I’d love a high polish on sterling rings, bezels or chain. For these occasions, I’ve made a series of hand polishing aids. And, because they are human-powered they’re portable — so I can also toss them in my toolbox to take with me when I teach.
Tools and Materials You’ll Need
- Chamois leather
- Wood paint sticks, dowels, or square rod in a variety of sizes
- Contact cement and a cheap paintbrush
- Sharpie marker
- Sharp scissors or utility knife
- Cutting surface
- Scrap paper
- Heavy book
Step 1 Choose a paint stick and mark where you would like the chamois to fit. The specific measurement is up to you, and the size of the wood and the size of the chamois will have to be factored in. The leather can be mounted from edge to edge of the stick, or in this case, at a length determined by the indent of the paint stick.
Step 2 Mark the center line on the back of the paint stick. Then, mark a straight line along one edge of the leather. To easily determine how much leather to cut to wrap around the stick, you can roll it from the line you indicated across the leather in four steps.
Then, mark another line for the opposite edge. Cut the leather strip on the lines, allowing a bit extra if the leather is very thick. Keep in mind it will stretch as you wrap it around the wood to attach it. It is not critical if the leather edges do not exactly meet, but if the leather is too long once it is wrapped around the stick the gluing will be difficult.
Step 3 Spread a generous amount of glue on the stick and allow it to dry for about 15 minutes. Most contact cement is ready to join when it is shiny and no longer tacky. At the same time, coat the back of the chamois with a generous amount of cement and let it dry for about 15 minutes, too.
Once the glue is dry, align the edge of the glued leather with the glue side down along the center mark on the back of the paint stick. Carefully press down the leather to bond the glue on both surfaces. Take care not to trap any air bubbles, and work slowly to bond the leather smoothly across the entire stick.
Step 4 Turn the stick over so the back is facing away from you, and then push short edge of the stick into the leather, pushing down to strengthen the glue bond.
Use your first finger and pinky to hold the leather firmly on the table, and at the same time, put pressure against the stick with the middle and ring fingers as you lower the stick on to the glued leather surface to bond the next surface. Smooth the bonded leather carefully.
Working out from the center of the stick, press the leather in with the left hand to prepare it for bonding. Use the right hand to gently press the leather down toward the center line and stretch it into the glued surface of the stick, taking care not to create wrinkles or air bubbles. Carefully smooth all sides of the stick and let the contact cement cure overnight. I put a heavy textbook on the stick to prevent anything from moving.
Step 5 Use a permanent marker to label the polishing stick with the compound you’ll use it with.
Charge the leather on the stick with the polishing compound and use it the same way you would use a sanding stick or file – either flat on the bench top, or by holding the work in your hands. I make polishing sticks in several sizes and shapes, and find that square sticks are particularly useful for polishing silver bezels or other 90-degree angles.
To store your polishing sticks, keep them in sealed plastic bags sorted by their compound. Like for the polishing machine, you should never mix up compounds, even on hand polishing tools.